Research articles
ScienceAsia 36 (2010): 150-156 |doi:
10.2306/scienceasia1513-1874.2010.36.150
Determination of trace levels of Pb(II) in tap water by anodic stripping voltammetry with boron-doped diamond electrode
Pipat Chooto, Puchong Wararatananurak, Chalermpol Innuphat*
ABSTRACT: A simple and rapid method to determine traces of lead in the Hatyai city tap water by square wave anodic stripping voltammetry with boron-doped diamond (BDD) electrode has been studied. The parameters in the preconcentration steps studied included electrolyte influences, pH, concentrations, and volumes. Effective preconcentration of trace lead was achieved at pH 1.26. The appropriate electrolyte was found to be 0.2 M potassium nitrate (KNO3) in 0.05 M nitric acid (HNO3) to make all lead ionic. By scanning potential in the negative direction, the stripping peak was obtained at −0.460 V. Instrumental parameters including deposition potential, deposition time, scan rate, modulation amplitude, and equilibration time were optimized. The detection limit was found to be 0.3 µg/l. The accuracy was verified by analysing the standard reference material. Several interfering ions were studied and it was found that the method was not significantly affected by these coexisting ions and can be applied satisfactorily to lead determination in water samples. The results from determination of Pb2+ using the studied method and ICP-OES were compared and found to be in good agreement. The concentrations of lead in various water samples from eleven regions in Hatyai city were found to be in the range of 0.0–0.8 µg/l, lower than the drinking water contamination standard (<10.0 µg/l) issued by the World Health Organization.
Download PDF
41 Downloads 1353 Views
| Department of Chemistry, Faculty of Science, Prince of Songkhla University, Hatyai Campus, Songkhla 90110, Thailand |
* Corresponding author, E-mail: chalermpoli@hotmail.com
Received 6 May 2009, Accepted 21 Apr 2010
|
